The AC4 WD:
+ Material mix of smooth leather and textile
+ elastic, pleasantly soft shank edge
+ textile lining (100% polyester)
+ Tightening aid (one loop at the rear of the shaft)
+ ankle protection on both sides
+ padded on the inside of the ankle with open-cell special foam
+ abrasion-resistant PU switching gain
+ climate-controlled insole, anatomically shaped
+ thanks to plastic-reinforced insole with hot-dip galvanized steel insert, particularly torsion-resistant and still easy to roll off
+ non-slip wedge rubber sole
Of course motorcycle boots are available for motorcycling. But you should also take a short stroll through the old town or into the ice cream shop or the way to work. On these meters, however, not everyone likes the stable hold of a high boot shaft. Here the AC4 WD offers – a boot, the upper of which only reaches the ankle. WD stands for „walk and drive“, the boot shows its good sides just as when walking as when driving.
It is comfortable to wear: This is ensured by the tightening aid, a loop on the heel. The entrance is very comfortable, closed with the lacing of the boot. Down the ankle, there are many proven Daytona qualities: The ankle protection on both sides and the elastic, soft shank edge provide support and are at the same time comfortable. The switch reinforcement is abrasion-resistant, the inner sole is reinforced with plastic and is particularly torsion-resistant thanks to a hot-galvanized steel insert. If you try a few steps, you will immediately notice: The stable sole is nevertheless easy to roll off and also in the terrain non-slip.
|Season||All year round|